* NOTE: MasterFlow intakes are built to work with Pyramid Reed Valves and stock reed cages. If using alternative brand of reed cage *Contact DRI.
A special MasterFlow intake may be required.


Purchase Options
Part # DR-3534 MasterFlow Intake Manifold System (34mm-35mm) $299.95
Part # DR-3526 MasterFlow Intake Manifold System (26mm-stock) $299.95

Replacement Parts
Part # DR-MFBTL MasterFlow Bottle
Part # DR-MFBR Bottle Rubbers (each)
Part #DR-MFFG-34 Replacement rubber flange

The use of MasterFlow intake manifold system and Pyramid Reed Valves is required to maximum performance out of larger aftermarket carburetors

Designed to work properly with larger carburetors. Stock intake manifolds are not designed to accept larger carburetors. If larger carburetors are force feed into stock manifolds they will split causing an air leak and engine failure.

Throat on stock manifolds are way to small to allow larger carburetors to perform properly

Not only does MasterFlow flange offer proper fit, but throat of manifold is designed for larger carburetors

MasterFlow Boost Bottle is built into the system, for added performance and reliability. Bottle capacity and feeder hole size is also changed to improve performance

Re-moveable Rev plate enhances low end power, but must be removed for use with PYRAMID Reed Valves

System also available with Rubber mounting flanges for stock carburetors. If purchased in this configuration, flanges may be replaced with 34mm-35mm models

MasterFlow performs best with PYRAMID Reed Valves