Yamaha Blaster MasterFlow Intake Manifold
Yamaha Blaster MasterFlow Intake Manifold
* NOTE: Masterflow intakes are built to work with stock reed cages. If using alternative brand of reed cage *Contact DRI.
A special masterflow intake may be required.
Purchase Options
Part # DR-3234 MasterFlow Intake Manifold System (34mm-35mm)
Part # DR-3226 MasterFlow Intake Manifold System (26mm-stock)
Replacement Parts
Part # DR-MFFG-34 Replacement rubber flange
The use of MasterFlow intake manifold system and Pyramid Reed Valves is required to maximum performance out of larger after market carburetor
Designed to work properly with larger carburetors. Stock intake manifolds are not designed to accept larger carburetors. If larger carburetors are force feed into stock manifolds they will split causing an air leak and engine failure.
Throat on stock manifolds are way to small to allow larger carburetors to perform properly
Not only does MasterFlow flange offer proper fit, but throat of manifold is designed for larger carburetors
Removable Rev plate enhances low end power, but must be removed for use with PYRAMID Reed Valves
System also available with Rubber mounting flanges for stock carburetors. If purchased in this configuration, flanges may be replaced with 34mm-35mm models
MasterFlow performs best with PYRAMID Reed Valves